CK INSTO PVT LTD

The cable is flexed 180° over Nylon blocks that have a 3” radius. The conductors in the cable are daisy-chained together and the continuity of all conductors is monitored continually. A fault in any conductor will stop the tester. There is 1 lb. of weight hanging on the cable as it is flexed. The tester runs at a rate of just under 30 cycles per minute or a little over 40,000 cycles per day. 

Cold Elongation test as per BS EN 60811-505 or IEC 60811-505 from CK Insto is use for cable elongation test.

Additional Information:

• Production Capacity: 300
• Delivery Time: 3 to 5 weeks
• Packaging Details: As per requierment

Cable flexibility testing is designed to determine whether the materials in a flexible cable can withstand constant flexing under electrical load

Hot-Wire Coil Ignitability Tester of IEC60695-2-20 Testing Equipment.To measure the time required to ignite the test specimen during the application of heat from an electrically heated coil as an ignition source, according to IEC60695-2-20.

This impact test apparatus is use to check cable gland strength. in this test 3 type of hammer use

Additional Information:

• Production Capacity: 500
• Delivery Time: 3 to 4 weeks
• Packaging Details: as per requirement

This CK Insto Tensile test apparatus application is check tha all material tensile  strength like gland, MCB,RCCB, Plug, Cable ,etc….

Additional Information:

• Production Capacity: 200
• Delivery Time: 4 to 6 weeks
• Packaging Details: As per requirment

The CK Insto Cable Pressure Testing High Temperature is used for the deformation of insulation and sheath of electric cable under pressure and temperature

Additional Information:

• Production Capacity: 300
• Delivery Time: 3 to 4 weeks
• Packaging Details: As per requirment

The machine is designed and manufactured according to the latest international and national standards for non-metallic material. It is used to measure HDT and Vicat temperature of plastic, hard rubber, nylon, electrical insulation material, long fiber reinforced composite material and high strength thermosetting laminate material.

Hot Set Test and Heat Pressure Test (with or With out HMI-PLC control):-
The instrument is manufactured as per the IEC specification and also confirms other international standards.

This machine is used for non-metal materials specimen testing, can customerized made to meet the standard of GB/T1040, GB/8804.1, GB/8804.2 and other standard specimen strip. The characters are simple structure, easy operation and low noise.

Additional Information:

• Production Capacity: 500
• Delivery Time: 3 to 4 weeks
• Packaging Details: as per requirment

The apparatus shall permit a sample to be bent backwards and forwards through angles up to180°, the two extreme positions making an angle of 90° on both sides of the vertical, whilst the sample is subjected to a tensile load.

The main function of this equipment is to test the physical and other related properties of the products in the simulated rainy weather for products such as electrical and electronic products, lamps, electrical cabinets, electrical components, automobiles, motorcycles and their components and parts. After the test, through the test to determine whether the performance of the product meet the requirements in order to facilitate product design, improvement, testing and factory inspection.

this device is use for measuring the impact resistance of electrical accessories at low temparatures, as well as wire and cables

Additional Information:

• Production Capacity: 500
• Delivery Time: 3 to 5 weeks
• Packaging Details: as per required